Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
- 8. Transmissions
   - 8.1. Mechanical transmission
      8.1.1. Technical characteristics
      8.1.2. Gearbox oil
      8.1.3. Gear shifting mechanism
      8.1.4. Gear shifting lever
      8.1.5. Gear shifting lever casing
      8.1.6. Connecting mechanism of the lever of gear shifting
      8.1.7. Speedometer drive
      8.1.8. Epiploons of half shafts
      8.1.9. Epiploon of an entrance shaft of the transmission
      8.1.10. Switch of lamps of a backing
      8.1.11. Transmission partition
   + 8.2. Automatic transmission
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







8.1.11. Transmission partition

GENERAL INFORMATION

The N KM-263 tool used for maintenance of the engine


Fastening of the transmission – model X 16 XEL

1 bolts of fastening of the engine to the transmission (3);

2 – bolts of fastening of an oil case to the transmission (3)


Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Disconnect the switching draft of the transmission from the connecting mechanism of the lever of gear shifting.
3. Disconnect a coupling rope from the lever on the transmission and remove it from fastenings.
4. Disconnect the socket of connection of the switch of lamps of a backing.
5. Disconnect the socket of connection of the sensor of speed and the oxygen sensor if it is necessary.
6. Disconnect a speedometer rope from the transmission.
7. Turn off and remove three bolts of the top fastening of the engine to the transmission.
8. Establish a support of the engine or the elevator, having hooked on the winch for the left lifting arm of the engine (see rice. The N KM-263 tool used for maintenance of the engine).
9. Lift a forward part of the car and install it on support.
10. Remove a protective guard of the engine if it is necessary.
11. Check reliability of installation of the winch or a support of the engine and remove a cross-piece of a forward suspension bracket.
12. Merge gearbox oil.
13. Disconnect half shafts from the transmission.
14. Disconnect a wire of "weight" from the transmission if it is necessary.
15. Remove a back cover of the transmission and laying.
16. Get an entrance shaft of the transmission from coupling.
17. Establish a trolley jack under the transmission.
18. Completely remove the left fastening of the transmission. On models X 16 XEL remove three bolts of the top fastening of the transmission to the engine (see rice. Fastening of the transmission – model X 16 XEL).
19. Turn off fixing bolts and uncover a coupling case. On models X 16 XEL remove three bolts of fastening of the engine to the transmission and three bolts of fastening of an oil case.
20. Turn off the remained bolts of fastening of the transmission to the engine and remove the transmission from the car.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down removals. Before installation check that two bolts fixing the left fastening of a box of transfers / engine to a body freely twisted in carving openings. If it is necessary, restore a carving by means of a tap of M10 x 1,25 mm.