Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
- 7. Coupling
   7.1. Technical characteristics
   7.2. Coupling rope
   7.3. Coupling pedal
   7.4. Coupling (models with a flat flywheel)
   7.5. Coupling (models with a profound flywheel)
   7.6. Release bearing of coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







7.5. Coupling (models with a profound flywheel)

Dismantling

PERFORMANCE ORDER
1. Because of the bigger size of a flywheel on these models for removal of coupling it is necessary to remove the engine or the transmission.
2. After removal of the engine or the transmission notice the provision of the mark in a flywheel coinciding with a cut on a coupling casing. Then gradually turn off six fixing bolts and remove coupling.

Survey

See subsection 7.4.

Installation

PERFORMANCE ORDER
1. Check that elements of coupling and a flywheel were pure, and on them oil or lubricant did not get. Before installation grease vents of a frictional disk with molybdenic lubricant.
2. Establish couplings on a flywheel, having combined a cut on a casing of coupling with a mark in a flywheel. Establish six fixing bolts and spring washers and slightly twirl bolts.
3. Center the provision of clutch plates by means of a round lomik or the long screw-driver inserted into an opening of a frictional disk. For this purpose it is also possible to use the special centering tool.
4. After centering of clutch plates gradually tighten fixing bolts of a casing of coupling till the required inhaling moment in a diagonal order.
5. Install the engine or the transmission on the car.
6. Check adjustment of a rope of coupling.