Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
- 6. System of decrease in toxicity
   6.1. Technical characteristics
   6.2. System of collecting crankcase gases
   6.3. System of decrease in toxicity of exhausts
   6.4. Catalytic converter
   6.5. System of collecting vapors of fuel
   6.6. System of recirculation of exhaust gases
   6.7. System of additional air supply
   6.8. Coal filter
   6.9. Ventilating valve of the fuel tank (TsVT and MW Multec model)
   6.10. Ventilating valve of the fuel tank (Motronic M 1.5)
   6.11. Ventilating valve of the fuel tank (Motronic M 2.5)
   6.12. Valve of system of recirculation of exhaust gases
   6.13. Pump of system of additional air supply
   6.14. Perepuskna valve of system of additional air supply
   6.15. Pipe of system of additional air supply
   6.16. Inlet collector (model 14 NV)
   6.17. Inlet collector (TsVT Multec models)
   6.18. Inlet collector (Multec MPi models)
   6.19. Top part of an inlet collector (Multec-S model)
   6.20. Lower part of an inlet collector (Multec-S model)
   6.21. Inlet collector (Motronic M models 1.5)
   6.22. Inlet collector (Motronic M models 2.5 and M 2.8)
   6.23. Inlet collector (Simtec models)
   6.24. Final collector
   6.25. System of production of the fulfilled gases
   6.26. Forward section of the exhaust system (DOHC model)
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







6.21. Inlet collector (Motronic M models 1.5)

Removal and installation

PERFORMANCE ORDER
1. Disconnect all air, vacuum and fuel hoses.
2. Disconnect wires and sockets of connection. Remove plaits of wires from a collector.
3. Turn off and remove a nut and a bolt of the top fastening of the generator.
4. Turn off fixing nuts (a photo at the left) and remove a collector (a photo on the right). Remove laying.
5. Installation is carried out upside-down removals. Replace laying.