Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
- 6. System of decrease in toxicity
   6.1. Technical characteristics
   6.2. System of collecting crankcase gases
   6.3. System of decrease in toxicity of exhausts
   6.4. Catalytic converter
   6.5. System of collecting vapors of fuel
   6.6. System of recirculation of exhaust gases
   6.7. System of additional air supply
   6.8. Coal filter
   6.9. Ventilating valve of the fuel tank (TsVT and MW Multec model)
   6.10. Ventilating valve of the fuel tank (Motronic M 1.5)
   6.11. Ventilating valve of the fuel tank (Motronic M 2.5)
   6.12. Valve of system of recirculation of exhaust gases
   6.13. Pump of system of additional air supply
   6.14. Perepuskna valve of system of additional air supply
   6.15. Pipe of system of additional air supply
   6.16. Inlet collector (model 14 NV)
   6.17. Inlet collector (TsVT Multec models)
   6.18. Inlet collector (Multec MPi models)
   6.19. Top part of an inlet collector (Multec-S model)
   6.20. Lower part of an inlet collector (Multec-S model)
   6.21. Inlet collector (Motronic M models 1.5)
   6.22. Inlet collector (Motronic M models 2.5 and M 2.8)
   6.23. Inlet collector (Simtec models)
   6.24. Final collector
   6.25. System of production of the fulfilled gases
   6.26. Forward section of the exhaust system (DOHC model)
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







6.18. Inlet collector (Multec MPi models)

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Disconnect an accelerator rope.
3. Disconnect an air branch pipe and cases of a butterfly valve.
4. Disconnect all vacuum, air and water hoses (on a photo the arrow showed a nut of connection of a hose of a servoamplifier of the brake system).
5. Disconnect all wires and sockets of connection from an inlet collector (a photo shooters specified fixing bolts of a wire of weight on the right side of a head of the block of cylinders).
6. Disconnect fuel hoses from fuel tubes (connection is specified by shooters a photo at the left (the car bottom view)) under a fuel collector. Close openings of hoses (are specified by an arrow a photo on the right).
7. Turn off a nut and a bolt of the top fastening of the generator
8. Turn off fixing nuts and remove an inlet collector. Remove laying.
9. Installation is carried out upside-down removals. Use new laying.