Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
- 6. System of decrease in toxicity
   6.1. Technical characteristics
   6.2. System of collecting crankcase gases
   6.3. System of decrease in toxicity of exhausts
   6.4. Catalytic converter
   6.5. System of collecting vapors of fuel
   6.6. System of recirculation of exhaust gases
   6.7. System of additional air supply
   6.8. Coal filter
   6.9. Ventilating valve of the fuel tank (TsVT and MW Multec model)
   6.10. Ventilating valve of the fuel tank (Motronic M 1.5)
   6.11. Ventilating valve of the fuel tank (Motronic M 2.5)
   6.12. Valve of system of recirculation of exhaust gases
   6.13. Pump of system of additional air supply
   6.14. Perepuskna valve of system of additional air supply
   6.15. Pipe of system of additional air supply
   6.16. Inlet collector (model 14 NV)
   6.17. Inlet collector (TsVT Multec models)
   6.18. Inlet collector (Multec MPi models)
   6.19. Top part of an inlet collector (Multec-S model)
   6.20. Lower part of an inlet collector (Multec-S model)
   6.21. Inlet collector (Motronic M models 1.5)
   6.22. Inlet collector (Motronic M models 2.5 and M 2.8)
   6.23. Inlet collector (Simtec models)
   6.24. Final collector
   6.25. System of production of the fulfilled gases
   6.26. Forward section of the exhaust system (DOHC model)
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







6.17. Inlet collector (TsVT Multec models)

Removal and installation

PERFORMANCE ORDER
1. Remove the fuel injection block.
2. Disconnect an accelerator rope.
3. Disconnect all vacuum, air and water hoses (on a photo the nut of connection of a hose of a servoamplifier of brakes (1) and the socket of connection (2) on the left side of an inlet collector is shown).
4. Disconnect all wires and sockets of connection from an inlet collector.
5. Partially merge cooling liquid.
6. Turn off a nut and a bolt of the top fastening of the generator, having remembered the provision of installation of a wire of "weight" (it is specified by an arrow).
7. Turn off fixing nuts and remove an inlet collector. Remove laying.
8. Installation is carried out upside-down removals. Use new laying.