Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
- 5. Power supply system
   - 5.1. Carburetor engines
      5.1.1. Technical characteristics
      5.1.2. Unleaded gasoline
      5.1.3. System of adjustment of temperature of the arriving air
      5.1.4. Air filter
      5.1.5. Fuel pump
      5.1.6. Fuel level sensor
      5.1.7. Coal filter
      5.1.8. Fuel filter
      5.1.9. Fuel tank
      5.1.10. Accelerator rope
      5.1.11. Carburetor
      5.1.12. Needle valve and float
      5.1.13. Vacuum diaphragm of a butterfly valve of the secondary camera
      5.1.14. Diaphragm of the concentrating valve
      5.1.15. Pump accelerator diaphragm
      5.1.16. Automatic air gate
      5.1.17. Diaphragm and solenoid of opening of the air gate
   + 5.2. Models with fuel injection
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







5.1.10. Accelerator rope

Removal and installation

PERFORMANCE ORDER
1. Remove the air filter.
2. Remove a clip from connection of a rope (a photo at the left) and remove the rope plug from an arm (a photo on the right).
3. Disconnect a rope from the lever of a butterfly valve on the carburetor.
4. In interior of the car release fixing clips and remove the lower panel of finishing on the party of the driver.
5. Remove fastening and disconnect a rope from an accelerator pedal.
6. Having remembered as the rope was laid, extend it in a motive compartment.
7. Installation is carried out upside-down removals.

Adjustment

PERFORMANCE ORDER
1. Adjustment of a rope is carried out in two places. For adjustment of the course of a pedal of an accelerator the lock screw serves. The tension of a rope is regulated by a clip on a carburetor arm.
2. Check that at the released accelerator pedal the rope was slightly weakened, and also check that at completely squeezed out accelerator pedal the butterfly valve was completely open.

ACCELERATOR PEDAL

Removal and installation


PERFORMANCE ORDER
1. Remove the lower panel of finishing on the party of the driver.
2. Remove a clip and disconnect an accelerator rope from a pedal.
3. Get to the check and a basic pin of a pedal (it is specified by an arrow). Remove plugs and a spring.
4. Installation is carried out upside-down removals.