Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical characteristics
   11.2. Rack of a forward suspension bracket
   11.3. Hug bearing of a forward wheel
   11.4. Lower lever of a forward suspension bracket
   11.5. Plugs of the lever of a forward suspension bracket
   11.6. Spherical hinge of the lower lever of a forward suspension bracket
   11.7. Stabilizer of cross stability
   11.8. Plugs of forward fastenings of the stabilizer of cross stability
   11.9. Cross-piece of a forward suspension bracket
   11:10. Nave of a back wheel
   11:11. Shock-absorber of a back suspension bracket
   11:12. Plugs of fastenings of the shock-absorber of a back suspension bracket
   11:13. Spring of a back suspension bracket
   11:14. Stabilizer(s) of cross stability of a back suspension bracket
   11:15. Back axis and levers of a suspension bracket
   11:16. Plugs of levers of a back suspension bracket
   11:17. System of adjustment of height of a back suspension bracket
   11:18. Elements of system of adjustment of height of a back suspension bracket
   11:19. Steering wheel
   11:20. Lock of a steering column
   11:21. Steering column
   11:22. Flexible rubber connection of a shaft of a steering column
   11:23. Rubber covers of the steering mechanism
   11:24. Steering mechanism
   11:25. Pump of system of hydrostrengthening of steering
   11:26. Tank of hydraulic liquid
   11:27. Hydraulic tubes of system of hydrostrengthening of steering
   11:28. Tip / spherical hinge of steering draft
   11:29. Steering drafts
   11:30. Adjustment of angles of installation of wheels
   11:31. Wheels and tires
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







11.9. Cross-piece of a forward suspension bracket

Removal and installation

PERFORMANCE ORDER
1. The cross-piece is removed together with the lower levers of a suspension bracket and the stabilizer of cross stability.
2. Before removal of a cross-piece of a forward suspension bracket establish an engine support, having hooked on the winch for the left lifting hook.
3. Remove forward section of the exhaust system and protective guards of the engine for access improvement.
4. Disconnect spherical hinges, the fixing suspension bracket levers to suspension bracket racks.
5. Check reliability of a support of the engine, then, turn off and remove two nuts and washers of back fastening of the engine/transmission to a cross-piece.
6. Establish a trolley jack under a cross-piece.
7. Turn off and remove six bolts fixing a cross-piece to a body (are specified by shooters).
8. Lower the jack supporting a cross-piece and remove a cross-piece from below of the car.
9. Installation is carried out upside-down removals. Use new bolts of fastening of a cross-piece.