Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical characteristics
   11.2. Rack of a forward suspension bracket
   11.3. Hug bearing of a forward wheel
   11.4. Lower lever of a forward suspension bracket
   11.5. Plugs of the lever of a forward suspension bracket
   11.6. Spherical hinge of the lower lever of a forward suspension bracket
   11.7. Stabilizer of cross stability
   11.8. Plugs of forward fastenings of the stabilizer of cross stability
   11.9. Cross-piece of a forward suspension bracket
   11:10. Nave of a back wheel
   11:11. Shock-absorber of a back suspension bracket
   11:12. Plugs of fastenings of the shock-absorber of a back suspension bracket
   11:13. Spring of a back suspension bracket
   11:14. Stabilizer(s) of cross stability of a back suspension bracket
   11:15. Back axis and levers of a suspension bracket
   11:16. Plugs of levers of a back suspension bracket
   11:17. System of adjustment of height of a back suspension bracket
   11:18. Elements of system of adjustment of height of a back suspension bracket
   11:19. Steering wheel
   11:20. Lock of a steering column
   11:21. Steering column
   11:22. Flexible rubber connection of a shaft of a steering column
   11:23. Rubber covers of the steering mechanism
   11:24. Steering mechanism
   11:25. Pump of system of hydrostrengthening of steering
   11:26. Tank of hydraulic liquid
   11:27. Hydraulic tubes of system of hydrostrengthening of steering
   11:28. Tip / spherical hinge of steering draft
   11:29. Steering drafts
   11:30. Adjustment of angles of installation of wheels
   11:31. Wheels and tires
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







11:25. Pump of system of hydrostrengthening of steering

MODELS WITH THE 1,4 AND 1,6 L ENGINE WITH THE MAPLE DRIVING BELT

Removal and installation

PERFORMANCE ORDER
1. Remove the air filter.
2. Take off a driving belt of the generator/pump.
3. Turn off three fixing bolts and remove a pump pulley.
4. For improvement of access remove the top external casing of a gas-distributing belt.
5. Disconnect a tube and a hose from the pump (a photo at the left) and close the ends of a hydraulic tube and hose for prevention of leak of hydraulic liquid (a photo on the right).
6. Remove the pump from the car.
7. The pump is not subject to repair and if it is faulty, the pump needs to be replaced.
8. Installation is carried out upside-down removals. Replace a sealing ring of connection of a hydraulic tube (it is specified by an arrow).

MODELS WITH THE MULTIBAND DRIVING BELT

Removal and installation

PERFORMANCE ORDER
1. Take off a driving belt of the pump.
2. Disconnect a tube and a hose from the pump.
3. Turn off and remove four fixing bolts (are specified by shooters).
4. Remove the pump from the car.
5. Installation is carried out upside-down removals. Replace a sealing ring of connection of a hydraulic tube.