Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
- 10. Brake system
   10.1. Technical characteristics
   10.2. System of anti-blocking of brakes (ABS)
   10.3. Protivobuksovochny system
   10.4. Hydraulic system
   10.5. Hydraulic tubes and hoses
   10.6. Brake overlays of forward brakes
   10.7. Support of a forward brake
   10.8. Brake disk
   10.9. Protective guard of a forward disk brake
   10:10. Brake shoes of back brakes
   10:11. Brake drum of back brakes
   10:12. Wheel cylinder of a back brake
   10:13. Brake overlays of back brakes
   10:14. A support of a back brake (model with back disk brakes)
   10:15. Brake overlays of the emergency brake
   10:16. Guard of a back brake
   10:17. Brake pedal
   10:18. Vacuum amplifier
   10:19. Unilateral valve (servoamplifier)
   10:20. Main brake cylinder
   10:21. Emergency brake
   10:22. Lever of the emergency brake
   10:23. Ropes of the emergency brake
   10:24. The valve of restriction of pressure in a contour of back brakes
   10:25. Switch of fires of a stoplight
   10:26. Switch of alarm bulbs of the brake system
   10:27. ABS modulator
   10:28. ABS wheel sensor of a forward wheel
   10:29. Electronic control unit and ABS relay
   10:30. Case of a butterfly valve
   10:31. Vacuum diaphragm of a butterfly valve (antitowing system)
   10:32. Electronic control unit (antitowing system)
   10:33. Switch of antitowing system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







10:22. Lever of the emergency brake

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Note regulator length, then turn off a nut of the regulator and disconnect a rope arm from draft. Remove the sealing plug from draft.
3. Remove forward sitting and the central console.
4. Raise a carpet near a casing of the lever of the emergency brake for receiving access to two fixing bolts of the lever of the emergency brake (are specified by shooters).
5. Turn off fixing bolts and disconnect the socket of connection of the switch of an alarm bulb of the emergency brake.
6. Disconnect wires and remove the lever of the emergency brake and draft from the car.

Partition

PERFORMANCE ORDER
1. For replacement of the gear sector it is necessary to beat out the fixing plug. At installation of the sector, install the plug so that between the gear sector and the lever there was a small free wheeling.
2. For replacement of a latch, drill a rivet.

Installation

Installation is made in the sequence, the return to removal.