Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
- 10. Brake system
   10.1. Technical characteristics
   10.2. System of anti-blocking of brakes (ABS)
   10.3. Protivobuksovochny system
   10.4. Hydraulic system
   10.5. Hydraulic tubes and hoses
   10.6. Brake overlays of forward brakes
   10.7. Support of a forward brake
   10.8. Brake disk
   10.9. Protective guard of a forward disk brake
   10:10. Brake shoes of back brakes
   10:11. Brake drum of back brakes
   10:12. Wheel cylinder of a back brake
   10:13. Brake overlays of back brakes
   10:14. A support of a back brake (model with back disk brakes)
   10:15. Brake overlays of the emergency brake
   10:16. Guard of a back brake
   10:17. Brake pedal
   10:18. Vacuum amplifier
   10:19. Unilateral valve (servoamplifier)
   10:20. Main brake cylinder
   10:21. Emergency brake
   10:22. Lever of the emergency brake
   10:23. Ropes of the emergency brake
   10:24. The valve of restriction of pressure in a contour of back brakes
   10:25. Switch of fires of a stoplight
   10:26. Switch of alarm bulbs of the brake system
   10:27. ABS modulator
   10:28. ABS wheel sensor of a forward wheel
   10:29. Electronic control unit and ABS relay
   10:30. Case of a butterfly valve
   10:31. Vacuum diaphragm of a butterfly valve (antitowing system)
   10:32. Electronic control unit (antitowing system)
   10:33. Switch of antitowing system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries







10:17. Brake pedal

GENERAL INFORMATION

The pedal of a brake is removed from the car

1 – clip;
2 – returnable spring;
3 – rotary pin

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the lower panel of finishing on the party of the driver.
3. Disconnect the socket of connection of the switch of fires of a stoplight, then turn the switch counterclockwise and remove it from an arm.
4. Remove a clip on the right side of a rotary pin of a pedal (it is specified by an arrow).
5. Take aside the end of a spring and remove a rotary pin.
6. Remove a clip on the left side of a pin.
7. Turn off a nut on the left side of a rotary pin and get a pin on the right side of a fixing arm.
8. Remove a pedal of a brake and a returnable spring.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down removals. Grease a rotary pin with molybdenic lubricant before installation.